Monday 16 May 2016

WIP: Antenociti 28mm 'Superhawk' dropship...

...built! I drilled and pinned the hull and cockpit in several places to help with alignment of the butt-joints. As all my builds are static and not gaming pieces I will leave the hull roof loose so the interior can be viewed. I'll probably put a couple of troopers  and other items(?) in the hold. The upper and lower ramps open and close too and visibility is quite good through the aperture. Engine pods are drilled and pinned also but I will most likely glue these in position when I place the 'Superhawk' on a diorama base.
I've only added a little light 'weathering' to the interior but may go back and add some dust to the corners once and the ramp after it's complete.








No comments:

Post a Comment